Straight answers and careful work on metal roof installation in Fairburn, GA. Metal roofing is our specialty, but we do the whole roof.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Fairburn install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Roofing Brothers has been doing metal roof installation since 2002, first around Morganton, North Carolina and now for Fairburn homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof installation starts in Fairburn you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
Questions homeowners ask us about this kind of work.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Fairburn homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Much less than people expect. Over solid decking with underlayment, a Fairburn metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Most Fairburn metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
A straightforward Fairburn house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
What people said once the job was finished and the trucks were gone.
"Showed up when they said they would, both days. That alone puts them ahead of the last three contractors I hired."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Roof on our shop building. They worked Saturdays so we did not have to shut the doors during the week."